Follow

Message “coresuite customize: coresuite designer has not been installed"

issue description

Upgrading coresuite modules to version 5.25 might result in error messages such as coresuite customize: coresuite designer has not been installed. Even after multiple addon/SAP Business One re-starts coresuite designer will not successfully upgrade/install and not be available; at times the issue only occurs a few days after an Upgrade.

 

troubleshooting steps/tips

The issue is primarily reproducible if "Fast Load" is enabled (Administration->Add-ons->coresuite administration->Global module configuration (Tab)->Advanced Settings (Button)->Performance Management (Tab)=>"Enable Fast Load") activated.

Please verify, if you are using this functionality.

 

solution

a) Fast Load is not enabled

  1. Please close SAP Business One
  2. Empty the temp folder (%tmp%) - ensure that coresystemsag_shadowing folder and its content is removed
  3. Restart SAP Business One via right-click->run as Administrator and start the coresuite addon

The coresuite designer should load successfully after a few SAP Business One/coresuite addon restarts. Once coresuite designer is running successfully, the other modules will also run without any issues. 

b) Fast Load is enabled

  1. Please disable "Fast Load" via Administration->Add-ons->coresuite administration->Global module configuration (Tab)->Advanced Settings (Button)->Performance Management (Tab)=> remove tick from "Enable Fast Load"
  2. Close SAP Business One
  3. Empty the temp folder (%tmp%) - ensure that coresystemsag_shadowing folder and its content is removed
  4. Restart SAP Business One via right-click->run as Administrator and start the coresuite addon
  5. Repeat steps 2-4 on every workstation 
  6. Reactivate "Enable Fast Load" again

 

Should contrary to our expectations the above steps not solve the issue for you, please contact support via helpdesk.coresystems.ch

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.